LOMAX Stance Hard Tri-Fold Cover - Urethane Carbon Fiber - 6 Ft. 6 In. Bed

The LOMAX is a low-profile, lightweight hard tri-fold cover built with aluminum panels and extruded-channel reinforcement—typically weighing around 40–60 lb depending on the model.  It sits flush with the bed rails (< ½″ above), maintaining a sleek, OEM-like appearance .  Available in various finishes: Black urethane finish, diamond plate, carbon fiber look, and professional series variants.

Purpose

• Protects cargo from theft and weather by fully covering the bed.

• Offers structural capacity: standard support approx. 400 lb, with the Professional series rated up to 500 lb evenly distributed 

• Enhances fuel economy and aesthetics by reducing aerodynamic drag.

• Maintains usability: fades into the background when you need full bed access.

Key Features

1. Automatic Dual & Ten‑Point Locking System
   Pulling release cords deploys heavy-duty nylon latches on both sides; closing engages ten locking points for secure closure 

2. Weathertight Seals & Water‑Shedding Hinges
   Overlapping side rails and reinforced hinges direct water away with no need for extra channels or drains. Owners report excellent waterproofing—even through car washes and storms 

3. Strength Without Bulk
   Reinforced with extruded aluminum channels, capable of bearing 400–500 lb load, while staying lightweight—typically 40–60 lb 

4. TIGHT BITE™ No‑Drill Clamps
   Installs with eight clamps that bite into the rail—no drilling required

5. Integrated Storage Clips & Noise Reduction
   Holds the folded panels in place, and rubber seals with minimal metal‑on‑metal contact ensure a quiet ride 

6. Tool‑Free Remove/Install
   Can be removed in seconds after folding and reclipped when needed—one-person operation

7. 3‑Year Limited Warranty
   Covers defects in workmanship under normal use

Installation & Care

Installation

• Rail Installation: Attach side rails using eight TIGHT BITE™ clamps—no drilling or bed modification required 

• Bolting the Cover: Slide the cover forward until hooks engage, then lower onto rails 

• No Tools—One Person: A single wrench for clamp adjustment; the cover can be removed by folding, securing with storage clips, lifting, and re‑hooking 

• Model‑Specific Instructions: Consult OEM placement guides for certain truck models (e.g., Chevy, Toyota, Ford) 

• Video Tutorial Available: A step‑by‑step install guide is available, and there’s a helpful YouTube tutorial showing quick mounting in minutes .

Care & Maintenance

• Clean Seals & Panels: Wipe rubber edges and hinges to ensure water-tightness.

• Lubricate Locking Components: Apply silicone spray or light grease to latch mechanisms periodically to maintain smooth action.

• Check Tightness: Inspect clamps intermittently to ensure secure fit.

• Touch‑Up Paint: Use kits for minor paint chips along edges to prevent corrosion

• Seal Replacement: Replace worn edge, front, or rear seals per manual instructions .

• Winter Storage: Use front storage clips to hold folded panels if removing during winter; prevents loss/damage.