Introducing Technician’s Choice® TEC70 TC Black Fusion…A low viscosity methoxy-methylphenyl oligomer coating that cures at room temperature. May be used on vinyl, polystyrene, rubber & polyvinyl chloride. Restores faded plastic & protects against acid rain, sun damage, chalking & detergents. May be used on car carrier trim, RV trim, truck beds, bumpers & other plastic, black & grey surfaces that are exposed to fading.

DIRECTIONS:  SHAKE WELL BEFORE AND CONTINUOUSLY DURING USE.  
It is normal for the pigment to separate and collect at the bottom.

NOTE: Excessive moisture will cause TEC70 TC Black Fusion to gel if bottle cap is left open. The surface which TEC70 is to be applied to is to be CLEAN & DRY with no water spots. Either tape off painted or glass surfaces near to the application area or keep a wet microfiber close by to clean up any excess. Make sure to wipe immediately.  Apply a small amount of TEC70 EVENLY to a clean, dry surface using an applicator pad or brush. Remove excess product. Allow to dry on surface 90 minutes, depending on climate conditions. Depending on the condition of the surface TEC70 is being applied to, the surface may require a second coat.

DANGER: COMBUSTIBLE. Contains Petroleum Solvents.  HARMFUL OR FATAL IF SWALLOWED.

CAUTION:  May cause eye and skin irritation. Use in a well ventilated area. Avoid breathing vapor or mist. Local 
exhaust preferred.